Certification & qualification
Signal Person / Rigger
Our class is built around the ASME B30 and OSHA 29 CFR 1926 Subpart CC standards. Successful students receive both a certificate and a wallet card. This is the 3rd party training both OSHA and General Contractors are looking for on the job site.

What’s covered
- OSHA and ASME standards
- Introduction, load weights
- Angles, stresses, center of gravity
- Sling hitches, sling types
- Rigging hardware, lifting devices
- Pre-use inspection of wire rope, slings, rigging hardware and chain & lever hoists
- Communication (all types), hand signals, conclusion
- Basics of crane operation and limitations
Class duration
5–6 hours
There is a test at the end of the course. Score 70% or higher to receive your training certificate and wallet card.
On-site at your location
We bring the class to your crew. Call or email to set up a date.
Free downloads: Crane Hand Signals Chart · Crane Rigging Reference Sheet